Holrits
-
Posts
3 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Holrits
-
-
Hi guys,
Could some one eplain me why my prints start to warp severeal hours into to printing???
The beginning it was fine, no warp at all. now i see some corners starts to bend.
I print with Ultimakers black PC.
The lid of my box was completely closed, now I have opened it a little bit, to let som of the warm air out, fearing
that it was because it was too hot inside??
regards Nicolai
-
Hi everyone.
The company i work in recently bought a Ultimaker 3, since we are going to make some End-Use holder for a
spirit bargun, I was told that the Ultimaker was the best 3D printer to go for, so we didnt need to use too much time
on setup.. I had just struggles abit, making the print "perfect"
Yesterday i finnally started up to print 6 pcs at the same time, but 30 min into the print, 1 of the units start to
warp in the corner.
I then restarted the process and instead of printing 6 i set it to print 3.
It then started again, but this time i noticed that the first layer wasnt really smooth, how can this be?
I have attached a picture of the layer, the nozzle of the Printer is covered in black filament...
I am printing these with Ultimaker PC filament.
Regards Nicolai
UM3 Small shift after only 15 prints?
in UltiMaker 3D printers
Posted
Hi everyone 🙂
I have recently bought a UM3 (1 week ago) and it have made around 15 perfect prints, of the same print.
When it came to the last print, it made a shift, I thought it was just a 1 time issue, i then made 1 more print
but it really made a bad print. I have seached the forum for all the adwise, and I have checked/lubricated everything,
just wondering if you have any good inputs after looking at my pictures?
Regards Nicolai