Sparkybruce
-
Posts
4 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Sparkybruce
-
-
The new file printed perfectly over the weekend so thanks for all your help.
Now I am trying to see why horizontal holes appear smaller than the models (which I think is down to the plastic shrinking somewhat during printing). I see between 0.5 and about 1mm under sizing.
Thanks again.
Bruce
-
Thanks for finding that - yes I did have avoid printed parts when travelling checked. I have cleared it now.
Searching through the file now for "Y-" it finds a number of other cases (but no X-).
So the safest thing is to do a (automated) search through my gcode files for moves outside the print area to avoid this error happening again in the future.
I was just surprised that Cura was happy to produce this error.
Thanks again
Bruce
-
Hi, I have been trying to print a large version of the one piece elephant so I scaled it up as large as I could in the latest cura software to fit on my UM2. I have a raft enabled to keep the model as large as possible.
When I try to print the file it gets about 11mm up then stops with the trying to print outside the printable area message. I have checked the file on the SD card for errors and it reads back fine. I have also tried printing it twice and it stops in exactly the same place.
Looking at the file with an online viewer the only thin that I can see is that at times the print head is moving outside the printed model and I am wondering if it is this movement which is outside the area , but as it is not "printing" it gets passed the cura normal checks.
I have attached a zip of the gcode file.
Any help would be greatly appreciated.
Thanks
Bruce
Coronavirus: Let's do our part
in Official news
Posted
Hi, I have two Ultimaker 2 printers (one at home and the other in my office) and about 100 reels of mostly ABS which I could put to use.
I am located near Peterborough in the UK.
Thanks
Bruce