Hi there,
Thanks for your feedback and suggestions.
Just checked the version on the printer, it lists 5.1.8.20181207. Think this is the latest Firmware isn't it ?
Primarily I was looking for if the flow control works for Ultimaker filament only. Based on your reactions, this doesn't seem to be the case (which is a good thing though).
Firmware doesn't seem to be suspect (if it is really the latest one).
One thing which comes to my mind is the screw on the feeder. I did not change the "pressure" on the filament. Just used it straight after unboxing.
I'm down to the point now, where I would try to "increase" pressure on the filament in the feeder by adjusting the screw on the feeder (see attachement).
But the printing results are anyways AWESOME!!
Nevertheless I would appreciate the Flow Control feature :-)
thx for your continued support