[Ultimaker S5 Camera Not Working]

I am running two S5's independently and have tried wired and wireless with no real difference.  

[Cura changed build plate size on S5 - parts no longer fit]

45 minutes ago, tinkergnome said:

 

This support page mentions all settings that have an influence on those "forbidden areas". It's still valid for the S5.

 

https://ultimaker.com/en/resources/44677-maximum-build-volume-ultimaker-2-plus-ultimaker-3

 

Good luck!

 

Thanks for the suggestion, but nothing changed when adjusting these settings.

[Cura changed build plate size on S5 - parts no longer fit]

3 hours ago, Framar said:

Is the machine settings are the same in the preferences ?

 

 

This is in 3.6

 

 

The machine settings are identical between both versions of Cura.

[Cura changed build plate size on S5 - parts no longer fit]

It is a dual extrusion with a prime tower but it worked perfect in Cura 3.6 so they changed the build size somehow and caused the problem.

[Cura changed build plate size on S5 - parts no longer fit]

I laid these parts out in Cura 3.6 about a year ago. Printing on S5 every week and worked great. I then upgrade the S5 with the Air Manager and need to reslice with Cura 4.4.1 to add build volume temp settings. Now it thinks the parts won't fit. I really need to over ride this or get it fixed!!

 

See attached screen shots.

 

Thanks for the help,

Roland

[Ultimaker S5 Camera Not Working]

I've had two S5 for a year now and there's never been a firmware where the camera has worked consistently good. Rarely works for more than a few hours after a reboot or a reset. It is really annoying as most of my prints are really long and it's nice to be able to check in on them.

 

Just searching again to see if anyone had a solution and decided I would finally add my complaint! Come on Ultimaker, get it fixed! Webcam is not a new tech!