carlosgalvezp

Hi, I have a piece that needs supports. I am using tree supports because they are much easier to remove (at least on the PLA roll I use). The problem I have is that sometimes the trunk of the tree is too small, and I get adhesion issues, ultimately leading to the support snapping off the bed. Question: how can I make the brim of the support larger, so that it does not get adhesion issues? I have tried the "Trunk diameter" and "Support Brim Width" options without effect, Cura silently caps it to a maximum. Thanks!

Thanks a lot for the reply @smartavionics! I checked the X-ray view and found the issue, will report it to the original author of the model! By the way, is this "Mesh Tools" a plugin I can add to Cura, or something I should activate? It looks very useful!

Hi! I'm using the official Cura 4.0 trying to print a model (attached). When I try to slice it everything goes fine except the shoulders - they appear hollow without material in them (see attached picture). However if I rescale the model to 50% then the shoulders are fine and well sliced. Why is this happening? Is there a setting I should turn on to fix it? This also happened in Cura 3.6 Thanks! jonesy.stl