StefV
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by StefV
-
-
Hello everyone,
I'm having some problems with printing Nexeo/DSM Novamid ID 1070 on an Ultimaker S5.
I'm experiencing some warping and bed adhesion issues. My parts warp in the corners and I also see that they partially come loose from the build plate..
I also enlarged the brim a little bit, I might need to make the brim even bigger.
I'm using 3DLac as an adhesive promotor.
I'm using printer settings provided by the supplier (I'll post them below).
I have a document from Nexeo where they give some advice when you are experiencing problems. Unfortunately this a little bit contradictory..
This is what they say:
Warping: Advice is to lower the build plate temperature.. etc.
First layer not sticking/parts coming loose: (amongst other tips) Advice is to raise bed temperature..
This are some of the print settings I use:
Print temperature: 255 °C
Bed temperature: 60 °C
Layer height: 0,2 mm
Should I raise or lower my bed temperature? And are there other tips to make sure my parts come out fine?
Thanks in advance!
Printing issues Nexeo Novamid ID 1070 Nylon
in Improve your 3D prints
Posted
Hello @gr5,
Thank you very much for your reaction! I will definitely change the bed temp to 100 degrees celcius and try it again!
Also, I try to keep the filament spool as dry as possible. We also have a filament dryer, so before I start printing again I will put it in the dryer for a few hours!