o_jr_o
-
Posts
3 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by o_jr_o
-
-
Hello,
The Problem:
I recently had this problem where the UM2+ would not start because of the bed not heating up.
So i ended up unscrewing the heat bed had found this on the connection terminal (See attached photo).
The UM2+ has a uptime of 7080h where 3078h printing, with 2258m of fillament that has gone thru, over 5 years of use.
Could this be thermal fatigue of the solder?
It could be when the solder broke there was still a connection but with higher resistance creating heat that melted the wire issulation?
How to resolve?:
Would it be as simple to recrimp the cable and resolder the terminal?
Or is there a place to only purchase the terminal?
-
Tree support generates the skirt outside of the printable area
in UltiMaker Cura
Posted · Edited by o_jr_o
Tree support generates the skirt outside of the printable area without giving any fault code. This is in Cura Ver. 4.13.1
should there be a warning atleast to notify the user of this?
attached is the projekt file.
852552668_CE5_ArduinonanoCNCShieldBoks.3mf