Hi everyone!
I already talked to support about this, sent them my BB print core for cleaning but while I wait, I'd like to get some opinions here.
My Ultimaker S5 wasn't doing well with PVA supports out of the box. Prints came off very messy, I have attempted to clean nozzle using cleaning filaments and PLA, but no luck, still lots of issues with printing.
This is what my regular PVA supports look like, PLA+PVA.
Cleaning didn't help much. I have a normal extrusion of cleaning filament when I do this. The only problem, probably, is cold pull - it's very hard do pull filament out and when it comes out, the end is still little soft (though I gave it enough time to cool down)
Anyway, sent my BB core back to manufacturer for cleaning, hopefully it helps but I have my doubts.
Swapped right core for AA core to try Breakaway PLA. Again, nozzle cleaned, did a small test print - all good.
First big print with it (1 day 8 hours) and I get this:
This is a 3rd party ABS with Breakaway PLA.
Same mess happens when I use Ultimakers Tough PLA with Breakaway, though in that case it's easier to clean.
Prime tower from same print:
Looked online for pictures of other peoples prints, supports look much cleaner than what I have even on best prints.
Can somebody give any hints to what might be wrong with my printer? Or maybe there's some settings in Cura i need to check?
To me it looks like the temperature might be too hot for these delicate support filaments and that's why we see all these strings and artifacts.
I also tried small test print with the same print core, loaded with CPE material (high temperature) - printed small hemisphere and it looked clean and consistent. So I assume problem is not with the core, but maybe something else?
Thanks,