[Overheating and small part issues]

It worked.  I might have gotten a bit carried away with the dummy towers, but it worked.  Finally an acceptable print! Thank you all for the help!

[Overheating and small part issues]

 Thank you for the reply.  I tried to print again with the cube towers and it is better, but still not clean or accurate enough to function.  Should I make the towers wider? Or do you think something else might be a good adjustment?

My settings were:

.2 layer height

infill 30%

temp 195

speed 60

minimum layer time 10

 

everything else was standard

 

[Overheating and small part issues]

Hello,  

       I have been using an S5 to try and print this band saw part in ultimaker PLA without any success https://www.thingiverse.com/thing:3471256

The main body prints perfect, however when it gets to the cylinder notches on the top they appear to be overheating and just melting the layers.  I have tried increasing the minimum layer time, slowing down the entire print, lowering the temp, printing multiple parts at once, a smaller nozzle, a prime tower, pausing after each layer of the cylinder, no infill- 100% infill, and I still cannot get a clean solid print. I even tried to print the cylinder separate in an attempt to glue it back in. 

     Any suggestions would be appreciated as I am starting to think this just isn't possible on my machine. 

bandsaw.stl