tinuviel88
-
Posts
3 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by tinuviel88
-
-
Thank you for the reply. I tried to print again with the cube towers and it is better, but still not clean or accurate enough to function. Should I make the towers wider? Or do you think something else might be a good adjustment?
My settings were:
.2 layer height
infill 30%
temp 195
speed 60
minimum layer time 10
everything else was standard
-
Hello,
I have been using an S5 to try and print this band saw part in ultimaker PLA without any success https://www.thingiverse.com/thing:3471256
The main body prints perfect, however when it gets to the cylinder notches on the top they appear to be overheating and just melting the layers. I have tried increasing the minimum layer time, slowing down the entire print, lowering the temp, printing multiple parts at once, a smaller nozzle, a prime tower, pausing after each layer of the cylinder, no infill- 100% infill, and I still cannot get a clean solid print. I even tried to print the cylinder separate in an attempt to glue it back in.
Any suggestions would be appreciated as I am starting to think this just isn't possible on my machine.
Overheating and small part issues
in Improve your 3D prints
Posted
It worked. I might have gotten a bit carried away with the dummy towers, but it worked. Finally an acceptable print! Thank you all for the help!