lawrie
-
Posts
3 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by lawrie
-
-
Hi,
I am getting the same error. It only started happening one on of our S5 pritners, and only after about 1yr of use. I am now getting an "error while processing. Line nr = xxx" once every 2 or 3 prints.
Things I've tried:
- reformatting USB stick.
- upgrading S5 firmware.
- different USB stick.
- re-slicing.
- upgrading/reinstalling cura.
This is critical for us as we are not allowed to put these devices on our hospital wifi networks.
-
Please can someone help get Cura working on the raise 3D pro2?! We need a single slicer that works across all our printers. Ideamaker is not that. If Cura cant we will have to abandon it also.
For the same settings ideamaker takes roughly double the print time than cura (bad travel move choices), creates supports that fall down, and has far fewer advanced options.
S5 An error occurred while processing...Line nr=31869
in UltiMaker 3D printers
Posted
In case it helps anyone, we solved this issue on one of our older S5 printers by performing the manual bed levelling procedure. presumably when the mesh bed level correction gets too big it can sometimes cause this "error in line nr ##" in the first layer (I was still getting this error using cura 4.12.1 & S5 firmware 6.5.3 until I adjusted the bed).