BryanU

DivingDuck, thank you for showing me where the JSON files are on Windows. It works. Smithy, thank you for your explaination and help. IT WORKS. I did try to write off the Disallowed Area in Ultiamker2_plus file first, but it didnt work. I then edit the Ultimaker2.def files instead, writing off the Disallowed Area and change the built volume of X,Y and Z. Now my models in Cura can fit into my built volume and slice without problem, while retaining the settings of Ultimakr2+ I had used. Thank you

Hi Smithy, Thank you for your reply and explaining step by step on how to delete the disallowed areas. But I have one problem. I went to open Cura (4.3.0) and at HELP -> Show Configuration Folder -> "definitions" folder (my folder is EMPTY). There's another folder called "definitions_changes" but inside are all "settings.inst" files. Where do I go about finding the ".def.json" files in Local C drive? Thanks in advance 🙂

Hi Everyone, New here. I have a custom built Ultimaker 2+ with a built area of 310 * 310. I have being printing and using the settings of Ultimaker 2+ with great results, but I had always print things within the area of Ultimaker 2+ bed. Now, I needed to make use of the 310 * 310 bed but the Bed Clip on Cura is at its original place even though I had change the Build Volume in the settings. I found in some thread here that I need to remove the disallowed areas from the .def.json file. But I couldnt locate the file at all and which part of the file I need to edit out. Hope someone can help. Thanks. PS: I know I can just create a custom profile in Cura with m custom built area. But I didnt want to change any of the settings since I am able to get good results from it. Thanks