Tamadite

Thank you very much for your supporting answer! The problem behind this case comes from a combination of PETG filament and overhangs. PETG does not like fan cooling and because of its elasticity the overhanging corner drags up with the seam when the Z lifts. This leads to noticeable imperfections and a higher risk of having the nozzle knocking off the object.

I'm on Cura ver. 5.5.0. I'm trying to avoid having the seam near the edges in the following object to not avail despite playing with seam settings. Look at the base of it. The object in question is in Thingiverse with name tumstock, link https://www.thingiverse.com/thing:6322311 Any hint?