Jump to content

Viggoman

New member
  • Content Count

    1
  • Joined

  • Last visited

Everything posted by Viggoman

  1. I'm experiencing a bed temp error message after e few minutes of printing. It seems to happen at more or less the same spot every time. Recycling the power clears the error, but it repeats after a few minutes. I have had a bed temp issue a few month back and followed the trouble shooting instructions, even replaced the main board. But it wasn't until I checked the wire connector at the bed it got solved. I have tried this out again to no avail. Any tips tracing the culprit of this? Thanks
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!