[Click to Resume]

I have setup Cura v4.5 after long time using V15.04

 

With my previous version, i never had any issues.
I have setup a custom printer and when i want to print the printer waits for a "Click to Resume" command on the display.

This happens after G29 autolevel. It also happens sometimes after heating up.
I have tried with a preconfigured printer that comes near to my custom printer, a anycubic i3, but it has the same issue.

Is there a setting that can avoid the "Click to Resume"?

 

I do also have a Anet A6, that is listed under the custom printers, but havn't tested it to see if it has the same issue.

 

Thanks in advance

-Roverius

[Error - Printing in the corner]

OK,

 

I misread, the Origin at center should NOT be ticked on. Lets try again :)

[Error - Printing in the corner]

Hello

 

I do have the same issue, i made just a test cube and placed it on the center of the bed.

I have a custum setup printer (FLSun i3 large) and ticked "Center" on.

Still, it starts to print on the corner. Cura V4.5
With Cura 15.04 there was no issue.