Galax-Ajh

Hi Good news. I've solved point 1 and 3. Point 1 : I've tried on a laptop without scrolling button. So it is impossible to scroll down to see other printers. When I installed Cura on my Mac, I don't even try the scrolling button. In fact, it's working and I can see other printers. Anyway, the tab for ultimaker printer does not close. Point 3 : The preview of the toolpath is only accessible with openGL vs 4. As I have an update to do, I have one of the two screen plugged on a old card witch does not support. Once, I have plugged the screen on the GT970, preview is again enabled. V.

Sorry, I'm a french guy and sometimes, I do not have the good word, so be comprehensive wtih my writing. My printer is a Dagoma Disco Easy 200 dual extruders and one nozzle and my system is Mac OSx High Sierra I have downloaded Cura 4.6.1 and I notice several issues: 1°) As noticed above, third party printers do not appears in the setup windows. No scroll bar and the tab does not close. The only way to select a thid party printer is to use the down arrow key. This issue is both on Mac and PC (Win 10) 2°) If there is a previous version, Cura send a message that there are some errors with the previous profile and propose to reset. In this case, all profils are lost. If I do not accept the reset, message comes again at the next launch. 3°) Because the app was very slow, I have to empty the cache. After that, I cannot retrieve the preview screen like before with the colors of material and the path of the nozzle with the progress bar on the bottom. The only preview that I can have, is line type. How can I get back the previw with the nozzle simulation 4°) I try the print in 2 colors. With the first tool selected, the nozzle does the skirt (2 lines) around the piece and the prime tower, after that, begins and fills completly the first layer of the prime tower. And then begins the piece. When it has finished its own part, then retract the flament and start the second color. The nozzle draw the skirt (only 1 line) and go to print the second part of the piece. The is no purge, obviously because the first layer of the prime tower is complete... On the second layer, the second tool does the job et give the hand to the first tool. The first tool goes to the prime tower, purges (do not fill it totally, only 2/3) and does its job for layer 2. On layer 3, the first tool finishes its jobs on layer 3 and give the hand to the second tool. The second tool (nozzle) goes to the prime tower and fill the rest (1/3) of the surface. But the remaining place is on layer 2 and we are already on layer 3. In my opinion, on the first layer, the nozzle must be purged twice, one per color after every part of the piece. On the other layers, every color must fill the prime tower, one color (purge) per layer. 5°) Gcode for the Dagoma printers nozzle are wrong. In fact, you have to invert the start and the end gcode on every extrudeur. I hope it is clear, mostly for the point 4. BR V.

Same issue, both on Mac and PC. No scrollbar and the tab doesn't close. You have to use the down arrow key to access to other printers. V.