Ian_Tranter
-
Posts
3 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Ian_Tranter
-
-
That's awful, we can't print a good part no matter what... Do you know if there is a contact number as I think there is a compatibility issue with the software?
If admin see this post please advice?
-
Hey There Friend.
Have you seen a solution to your issue, I'm experiencing the same issues and have done almost everything you have apart from checking the firmware.
I also print with a brim and have only seen this happen on software version 4.2.1., see images attached
Please advise of any solution you may have?
Does anyone know of a phone line for support?
Printing misaligns each new layer
in Improve your 3D prints
Posted
@Torgeir No I haven't, I'm just running through the two help files above, will check that also,.
Regards
Ian