chrisinullapool

Update, I found where my problem lies, it's saving a code for the start of each print, I pulled this apart and got closer results could someone please explain what each of these steps are exactly so i know which to change G28 ;Home G1 Z15.0 F6000 ;Move the platform down 15mm ;Prime the extruder G92 E0 G1 F200 E3 G92 E0

New to 3d printing, prints were working ok until I updated to cura 4.6, now the printer is automatically starting way off on the z axis and is hitting the sides of the print plate holder. I tried to fix this by setting the print area to smaller than my print surface area but the problem is still there (original build was ultimaker cura 3.2.1)