Jump to content
Ultimaker Community of 3D Printing Experts
  • Sign Up

flux_capacitor

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. This is untrue. PrusaSlicer does have the option to insert remaining time in Gcode, so that latest Prusa i3 printers display time remaining instead of elapsed time above filename.gcode on screen. As for PrusaSlicer 2.2, the option is located in Printer Settings → Supports remaining times. The tooltip states "Emit M73 P[percent printed] R[emaing time in minutes] at 1 minute intervals into the G-code to let the firmware show accurate remaining time. As of now only the Prusa i3 MK3 firmware recognizes M74. Also the i3 MK3 firmware supports M73 Qxx Sxx for the silent mode." Therefore, for Prusa i3 MK3 and MK3S printers, the question remains: is it possible for Cura to do the same, and how? If Cura cannot do it currently, then when?
×
×
  • Create New...