-
Posts
5 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by eric_huang
-
-
40 minutes ago, eric_huang said:
I found it~ Thanks
-
On 11/15/2020 at 2:50 AM, Smithy said:
I have installed "z offset" Cura, but how use it?
On 11/15/2020 at 2:50 AM, Smithy said:Maybe your glass is not really flat?
But you can also turn off the auto leveling completely, for the size of the bed it is not really needed and you are much faster with starting a new print without the leveling. I have turned it off and just do a manual leveling again after a few months.
Another workaround would be to install the z offset plugin in Cura and adjust it to your needs.
-
-
It was good at first, but then it was a nightmare
in Improve your 3D prints
Posted
I handed the machine to the agent for inspection, and found that the pulley was skewed, and the entire feeder had to be replaced. The cost was USD150...OMG