zeeg617
-
Posts
5 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by zeeg617
-
-
No, I did not. How should I do that? Thanks.
-
Hello,
I have been experiencing some issue with one of my nozzle recently. As the title said, the AA nozzle does not extrude filament during printing. However, when I load the new filament the filament came down from the nozzle normally. It is only during printing nothing comes out. Is there a fix to this issue?
The things I did before the issue occurred were:
1. Printed with CPE+
2. Switched to PLA
Best
-
-
Hi,
When I printed with CPE+ on Ultimaker S5 with the default profile applied glue stick on the bed before printing. The first layer looked really bad and I don't know if that's normal. Could you take a look and give some advice? The nozzle was also covered with white CPE+ filament when I abort the print.
Is this because the bed is too hot? How can I change it so it can look as good as I print with tough PLA?
Best
Ultimaker S5 Filament won't unload
in UltiMaker 3D printers
Posted · Edited by zeeg617
Hi,
I have a critical issue with filament.
Issue: PLA Filament does not unload when press the unload button, motor sound was normal, but the filament did not move.
Observation: I heated the nozzle to 220 degree, then I lifted the lever on decoupler and tried to pull the filament out manually, but it is not moving. I opened the cover of the decoupler. I tried to pull the filament by hand again, it seemed I was not pulling the filament but the tube, the inside of the decoupler looks fine, nothing is stuck in there.
I tried to choose the load filament option but does not see any extrusions.
Suggestions? I want to hear some expert opinion before I forcefully remove the printer core and cause damage to the printer. Thanks.