RC3141

I've recently taken to trying to print miniatures on my Ender 3 Pro (with direct drive) and I'm seeing Cura 4.6.2 generate supports that are Not attached to anything on the bottom (or extending out into midair) Not attached to anything on the top I don't want to set my supports to "From Buildplate" because I'm printing the minis on a base, so "From Buildplate" would cause the print to not be properly supported. I've messed with the X/Y/Z distance for supports, which causes the existing unsupported supports to look better but then adds more of the same issue in other places. I am printing this model at 110% scale, attached are photos of the issue as well as my support settings