UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
@GregValiant
Thank you all, some more info:
- Glass bed
- PLA
Next try I will try to use a glue stick and make sure the bed is clean
Will also go up from 60C to 65C and see how it goes
Hello,
I'm having an issue where my print is up in the air on one side of a circle, can't figure out what causing this.
Using Cura 4.8, Ender 3 v2
Attached is pictures of the print and the settings I am using
Any ideas...?
Thank you!