Jump to content
Ultimaker Community of 3D Printing Experts

SirFelonious

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. In Cura, is there a way I can designate specific blocks of an object to trigger a filament change? (single extruder) For example: I would have about a millimeter tall cylinder of white filament surrounded by a ring of blue filament. Basically the nozzle will print out layers 1 - 100 of the white, then change filament, then goes back to print layers 1 - 100 of the blue. (I can add a picture if I'm being unclear) This is similar in concept to non-planar printing but it prints planar for one section then again for another. I understand that I may need to change the filament multiple ti
×
×
  • Create New...