jimb0slic3

Have the exact same issue that I've been chasing for over a month. I've printed two dozen calibration prints and there's still a slight gap between circular inner walls and skin (green and red walls) no matter what I adjust. I can make it almost go away overcompensating some settings, but then the rest of the print suffers. After reading this thread, I downloaded PrusaSlicer today and with zero calibration or settings adjustments there were no gaps, but the rest of the print was a mess. I copied over my Cura settings to PS and everything prints perfectly. Picture attached - Left is Cura with my normal .2mm height profile, Center is Cura with settings over compensating for the gaps at .1mm height, Right is PrusaSlicer with the same settings as the left .2mm print. Point of story, it seems to be a slicer issue somewhere. Happy to upload the .stl or gcodes if that helps troubleshoot.