Jump to content
Ultimaker Community of 3D Printing Experts

jfrench3000

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Print core is clean, front fan is fully operating, feeder tensioner is in middle position. Print temp is 200 C and speed is 70mm/s. If any other suggestions ill advise. Thank you
  2. The tough PLA is getting stuck and the wheel that feeds PLA is just spinning, causing a half moon wear mark in PLA
  3. Since running Firmware update our Tough PLA is binding up in Bowden feed. I have ran Hot/Cold pull and still having issue.
×
×
  • Create New...