shanta

I switched to a different filament and the problem disappeared. Not sure but that may have been the problem. I went back to the filament setting and it then worked likely due to resetting of the variables. I had a feeling it was a new bee problem. Thanks so much for the support. Shanta

Hi I just downloaded and ran 4.9_20210511_Ultimaker_Cura-4.9.1.AppImage Previous version was Ultimaker_Cura-4.9.0.AppImage Since running the new version both slicers will do the fallowing. should look link this Any suggestions as to what went wrong and how to fix it? Thanks Shanta