hekistner

When I print through the USB port the printing does not reset the software when the item has been completely printed. I have to do it manually before I can start another part printing.. Is this normal or is there a setting I can change in Cura to do this.. Also in the monitor setting where you can set the preheating the bed preheat works fine but the nozzle preheat can be started at first but after the first cycle them it becomes inoperable and I have to go to the printer and select the nozzle preheat. I can close out Cura and restart it and the screen preheat will work. I have notice that on the monitor screen the Z and XY home selections do not work and the Z control works backwards. The first time I tried to use the Z control I drove my nozzle into the bed because I selected the down and the bed went up so had to select the ^ to get the bed down I sure was surprised. These items maybe right to others in their thinking.. As a newb to the 3D printing world it has sure been a learning experience... Thanks Harold