rdym
-
Posts
4 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by rdym
-
-
@ccr90, I currently have Cura 4.10.0 installed and firmware 6.5.1 installed on the S5. I do not have the material station installed.
-
I don't believe so, I leave the doors and air handler shut during the change, so I'm not sure what I would be bumping it with. I will try to do a test on a small print to see though.
-
Hi,
I've been having trouble with changing filament mid print on the S5, if the filament is changed mid print then when printing resumes the head will bury itself approximately 1 mm too low in the print destroying the part. Do you know if there is a setting I'm missing whcih is causing this, or whether it is just an error? For my most print this occured while using the 0.8 mm nozzle.
(Cura 4.10.0, Ultimaker S5, 1x 0.4 mm printcore, 1x 0.8 mm printcore)
Print head too low after changing filament mid-print on S5
in UltiMaker 3D printers
Posted
@CarloK, no I haven't been using pause at height. Would using this help my situation?