Tneptunus

So, I use the cr-10 profile for my anycubic chiron as that is the way I've had the best prints, with a few small adjustments. When updating from 4.10 to 4.11 it kept all my settings for the profile and I sliced an object saved it to an SD card and put it to print. Normally what happens is it wipes a small line then begins on the brim, what is happening is it will begin to pump filament through as fast as possible, travel on the Y axis, reach the travel limit, then begin travel on the X axis, hit the limit and I do mean HIT the limit and attempt to continue going all the while feeding filament through. I had assumed this was a faulty file so I resliced, saved and tried again. Same thing. Tried a different file, same thing. Closed and reloaded cura, same thing. I then tried a custom chiron profile I had made but wasn't getting quite as good of results as from the cr10 profile and it worked with no issues but the print still wasn't as good as what I'd been getting with the cr10 profile so I ended up rolling back to 4.10. If anyone might know what's going on I'd love to have the update version as I do like the UI more.