HienoKaveri

Either bow?

Ah.. I believe that is normal, I just found out about Z seam alignment. I feel like a dill hole. Can I delete this thread?

Pic says it all. That is the point where each layer starts and stops printing.

*sigh* Glad it was this simple..

Hi, I'm pretty new to printing. I have an Ender 5 Pro with BLtouch, and ran into this issue while printing. Using eSun PLA+, 210C, 65C bed, 0.2layer, speed 60mm/s. There is this strange layer that appears randomly, as seen in the pictures. If I print again with same settings, result can be perfect. Also no telling where and when this happens. The red object is not solid, walls are a few mm thick. Same thing on the gray box, some layers are ruined all of a sudden, then it gets back to normal. I'm sure someone has seen this type of behavior before? What's the deal? thanks. HK