Hi, I need to make a small rubber part for an old car I'm working on. It's just a boot to cover the back of the ignition switch. I googled around and found an Atomstack 3d printer that prints using TPR filament. It just seems a lot easier to use 3d printing than making rubber molds so I bought the Atomstack.
I made a tests and finally got one that works well but I needed to modify the dimensions a bit. I'm using 3DS Max for the modelling. For some reason the preview doesn't show any infill on my latest two versions but it does show on the last test run I made. I haven't bother to print that ones that aren't showing any infill because I know they'll collapse.
Any suggestions?
Thanks
infill problems.3mf