[Ultimaker Cura Adaption to BLTouch]

Hello! I use a BLTouch with an Ender 3V2, and I am having issues with getting an automesh to be read. I am able to create the mesh properly, but do not know how to go about applying this mesh to prints. Everything I have seen says to add the code down below to the GCode files, but it does not seem to make any difference as the nozzle height is not moving or adapting across the bed. I know this forum does not apply much to the hardware, but I was hoping there was something I was missing on the software side of things! Any and all help is appreciated!

[When trying to print an STL File found online, chunks are continuously missing when slicing is attempted]

8 minutes ago, GregValiant said:

Well this would do it...
-> Analyzed your file:
--> 2041 Naked edges (?)
--> 35 Planar holes (?)
--> 91 Non-planar holes (?)
--> 1 Non-manifold edges (?)
--> 51 Inverted faces (?)
--> 0 Degenerate faces (?)
--> 2 Duplicate faces (?)
--> 0 Disjoint shells (?)

-> Vertex count changed from 39462 to 48011 (+8549)
-> Triangle count changed from 76715 to 97056 (+20341)

The web service was able to repair it.  Whether it's right or not I don't know.  Your model is on the right.  The pink areas indicate errors.

 

You won't print this with a .4 nozzle at 100% scale.  You would need to go to 200% to have a chance and the line width would need to be .35.  A .2 nozzle would be a better choice at full scale.  Some of the supports would be difficult to remove without trashing the print.

Okay thankyou so much! Interior didn't matter as much, as I was just using it for the shape! I wasnt sure how to go about repairing or anything like this so this helps a lot!!!

[When trying to print an STL File found online, chunks are continuously missing when slicing is attempted]

Hello! I am looking to print out the following file laying on its side as a piece to decorate my graduation cap, but whenever I go to print it, it is consistently missing chunks of it. When standing vertical, it misses pieces of the bell, when on its side the entire bell is gone. Is there anything I am missing, any way I can repair the file, anything like that? All help is greatly appreciated!

Saxophone Half.stl