Ikaru31

If there is someone also trying to use cura on a Bfb 3d Touch here is how i managed it to work: create a standard fff-printer in cura change start gcode to: ^Checksum: NO ^Time: 1234 ^Ex1: PLA White ^Ex2: PLA white ^Ex3: None M227 P3200 S3200 M105 M113 S1.0 change end gcode to: M103 (</nestedRing>) ~M104 S0 M113 S0.0 Change extruder 1 Start gcode to: ;extruder 1 M106 M542 ;start extruder 1 extruding M107 M104 S{material_print_temperature_layer_0} M106 M551 P57600 S600;priming p-extrudingmass s-speedofextrusion M543 M101 Change extruder 1 end gcode to: M103 Change extruder 2 Start gcode to: ;extruder 2 M542 ;start extruder 1 extruding M107 M204 S{material_print_temperature_layer_0} M106 M552 P57600 S600;priming p-extrudingmass s-speedofextrusion M543 M201 Change extruder 2 end gcode to: M103 Printer settings: x 395.0 y285.0 z201.0 origin at center gcode Flavour Bits from bites Nozzeloffset x extruder 2 50mm Print settings custom expert: flowrate to arround 4700 uncheck infill bevore wall Buildplate adhesion :none (Change in flowrate strangly does not apply here so its not extruding the raft until you change it manually) slice your stl and save gcode open the stl with notpad or simillar open an .bfb made with axon and delete everything Copie the gcode from cura in the .bfb file and save. This is necessary to avoid an file read error, may be possible to do otherwise. At the printer settings of the bfb you have to uncheck the chek file before printing

Hey after weeks of try and error i finally got the old Bfb 3d Touch from my University to work with cura. But right now i have to change the gcode everytime i use extruder 2. The Bfb 3D Touch can work with up to 3 hotends, currently equiped with 2 hotends. So far i got it only to work with 1 extruder at a Time, because f the following issue: The bfb uses the comand M104 {prin_temperature} for hotend 1 and M204{prin_temperature} for hotend 2. But when cura changes the temperature it uses m104 everytime so only hot end 1 is heating. My fix is currently to edit the gcode when i use extruder 2 and change every M104 to M204. But when i use both extruder at the same time i can not tell wich m104 has to change and wich not. Sadly it didnt work to implement the m104/204 in the start gcode of the extruder. Is there a way that cura uses the right m104/204 depending on wich extruder to use next? Another minor issue i have is, that the flowrate has to set to 4700% and because of that the lines in the prview are so thick that you can not see whats going on. is there a way that cura does not refere to the flowrate for the line thickness in the preview or another way of setting the flowrate to a correct level?