Anychris

Hi, Cura only saves when you restart it. I am so sorry, I didn´t know that... It is working now. but thank you for the tipps it lead to the solution. While I´m here do you guys know how to add a Z-Offset to the I3? It seems that it can not be done in the printer itself only through software. I have Pronterface and Cura. Is one of the two able to do this? Thank you for all your help and the time involved 😉 Chris

I did that already unfortunately no help😪

Hmmm really don't know where to write in this code....

Hello, i am new to 3D-Printing and I have the Problem that whenever I slice with Cura and sent to my printer either USB or SD it will print on the extreme front left corner. Not even the full model only its outmost upper right edge. When I print the generic owl model from anycubic it will be in the middle of the bed so i assume problem is with Cura!? Moving the Model on the Cura table has no effect on the actual print location on the bed. What do I miss here? I already selected "Origin at Center" in Printer settings and "Apply Extruder Offset to Gcode". My Printer is a Anycubic I3 Mega S with Firmware 1.15 and Cura 5.1.0. I am really helpless what to do.... Chris