Hi Ultimaker Team/Community
I'm looking for some advice. I have an Ultimaker 2 extended.
As I'm sure you are well aware, the normal operation after a print; is for the print head to return home. Then when a new print starts the bed lifts to about 2cm below the print head, and the head will move to the front left and extrude(Purge the hot end) then move to the start of the print, and then start to print the first layer.
My printer prints 100% - No problem with printing!
My issue is... it does not send the head back home,
Not after bed levering
Not after a print.
Or on startup
When I start a print, what happens is this; the printer moves the head forward as if the "IT believes the head was at the "Home" position Top Left!
But it moves forward then the stepper motor slips the belt "Until IT believes the head is now at the ready point to start the print/extrude/Purge"
The Left to right axis works 100%
Then the normal print sequence starts and it prints 100%
After the print, it moves all the way to the left but not backwards, it stops at the same level the the print ended at and it does not return home on that axis....
What can I check? As mentioned it prints 100% I can post a video if it will help.
https://drive.google.com/file/d/1-6VnxWRQ-lBh14UoNG9h2X5oEjvgG2wA/view?usp=sharing
Thanks, Schalk