Opaaleks

Thank you, I will try - learn

Thanks for the answer. Of course, I apologize, but my information was a little inaccurate, since I write through google translate. I had to go back to version U. CURA4.13.1, because in versions 5.0.0 and 5.1.0, after the end of printing, the extruder goes to the parking lot in the far right corner of the table. Correctly, it should park in the left near corner of the table. Do not tell me what needs to be done, changed? Thank you!

Tronxy X5SA is not friendly with Ultimaker-Cura-5.1.0-win64. Windows 11 PRO. I have had a printer for two years now and have been using Ultimaker-Cura all this time. Before Ultimaker-Cura5.0.0 everything was OK. Updated to version Ultimaker-Cura5.1.0 and there were problems. I already thought something happened to the printer. But no - Ultimaker-Cura5.1.0 is to blame. Problems: 1. In previous versions, at the start of printing, the table and the extruder started to heat up together, in Ultimaker-Cura5.1.0, the table heats up first, then the extruder starts to heat up. Time is running out! 2. And the most important problem is that in the Ultimaker-Cura5.1.0 version, after the end of printing, the print head does not park normally, it "runs" to the far right corner of the table until it stops!!! Returned to version 5.0.0. Here are the test print details gcode. TXXPRO_Ultimaker-Cura4121.gcode TXXPRO2E4_Ultimaker-Cura5.1.0.gcode