miaooo
-
Posts
6 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by miaooo
-
-
Hi, @MariMakes, after updating, I start to face with an error called “Nozzle offset probe failed. Please check the nozzles and bed and try again.” how can I solve it?
-
On 9/29/2022 at 6:00 PM, MariMakes said:
Hey @miaooo,
That's not the latest firmware 😮
You can install the latest version 7.1.3 here
https://support.ultimaker.com/hc/en-us/articles/360011545559
You'll get some other sweet bug fixes as a bonus.
Good luck 💪Hi, after updating I facing with an error called “Nozzle offset probe failed. Please check the nozzles and bed and try again.” how can I solve it?
-
hi, thanks for replying fast.
the Ultimaker s3 which i currently facing problem with now is at the latest version of the firmware 5.8.2.😥
-
constantly getting "Difference Between detected height of both print cores exceeds realistic" error. The building plate and print core were cleaned. filament in the tube as shown in Figure1 & 2 become that when waiting for the printing to start. Figure 3 was did by the insert of the filament area. the build plate was adjusted to the lowest as the tip of the print core touches the build plate when waiting for printing.
-
wanted to printing small keychain with ultimaker 3S, my laptop has the latest version for ultimaker cura 5.1.1, however the printer shows that the file was in the older version of ultimaker cura. needed to be with version 4.4 or above. what was the issue in it?
HELPPPPP
in UltiMaker 3D printers
Posted
Hi, the left nozzle was up, the build plate was set to the end. Nothing was wrong with sensor too. May I know what other issue could there be