HuszakM

This is exactly what I was looking for! But this is what happens with me: Any suggestions?

Hi there: I print mostly organic, detailed models and therefore we use many PVA support. After that, because of the big size of the models, the dissolving process takes hours. During that, the modell usually gets filled with water which is hard to remove from inside the model. What I would like to achieve, is to add a hole, before printing, so I don't have to drill the model. For example on the picture, I want to create a "booelan", so I can see "inside" where there's infill. Do you think it's possible without editing G codes? Thank you!