lodebar

@GregValiant I am hoping even birthday candles wouldn't fit! lol This is one of the finishing touches for a dice tower for dnd so it's relatively small scale.

thanks so much for your time, and for all replies above. I will try to mess around in cura to figure out how to adjust the size of the holes, I will need them a bit larger to run wire through. Thanks!

I have a file (attached) that I removed a section from on the largest brazier in blender. Now Cura is filling in the hole I intentionally made. I am going to run a wire through this and it would be helpful to have this section open. I have tried to flip the normals without success but will admit I am a bit out of my depth with blender. I have played around in Cura with removing fill gaps between walls and such but it still shows it being filled when I slice. Now I am afraid I have my Cura settings all out of whack lol. Any suggestions or does the model need fixing? brazier.stl