dyeatman

New member

Personal Information

dyeatman started following Cura 5.7.0 won't slice a model that fits on the Ender 3 Max Neo build plate/says its too big April 25
Cura 5.7.0 won't slice a model that fits on the Ender 3 Max Neo build plate/says its too big

dyeatman posted a topic in UltiMaker Cura

I created two parts that were near the max X limit (setting is for Ender 3 Max Neo 300x300) and the slicer won't accept it. The original was 298mm in the X direction and 175mm in the Y direction that it wouldn't accept.so I reduced it down to 285mm and it still wouldn't accept it. I then brought it down to 253mm, no luck. However, if I scale the 253 model in Cura to 95% it will slice. The full size version slices with no problem in Creality Slicer and two others. The project I attached is the 253mm version. Exhaust vent bottom modified.3mf
- April 25
- 1 reply