Bigiron750

Thank you Greg I went into ms 3d and found a small hole in the file. So cura was pulling the whole peice out. Repaired it and it now slices fine. Thanks again

So if the one that is flipped and looks good would it print without a gap?

The 2 pictures are of the same file one is just flipped up side down and the gap goes away

Why is that if I rotate 180 degrees so flip it upside down it is fine ?

Hello I am new to 3d printing. I have been using cura slicer since I started. I am printing a boat hall and when I rotate it 180 degrees it gets a space between the print . Was wondering if anyone has seen this before and how can I fix it? I attached 2 photos. The first one is the way i would like to print it but it gets that space missing. The second one is if i rotate 180 it is fine. Thank you