Jump to content

jhelmstetterjr

New member
 View Profile  See their activity

  • Posts

    2

  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other 3D printer

jhelmstetterjr's Achievements

0

Reputation

1

Community Answers

  1. jhelmstetterjr
    Okay, I figured this one out. When you specify firmware retraction, you still have to enable retraction in the Travel settings.
  2. jhelmstetterjr
    I have a CoreXY printer using a Duet3D Wifi. I enabled firmware retraction in Cura 5.2.1, but when I slice, the gcode generated does not have any G10/G11 codes present. I found an earlier post about this but I do not believe this is the same issue. Am I missing something?
×
×
  • Create New...