I am trying to use Cura 5.2.1 to slice for my Raise 3D N2 - single extruder. The printer is setup properly in Cura as a single extruder. When I try to load the gcode on the Raise printer, I get the following error on the printer: The printer only has a single extruder and cannot print dual extrusion gcode file.
Any suggestions on how I can fix this error?
Below is the printer start GCode
G90
G21
; home all axes
G28
G92 X0 Y0 Z0
; move heatbed into position
G1 X20.0 Y20.0 Z1.0 F1000
; zero extruders
G92 E0 E1
T0; right tool
; set extruder steps per mm
M92 E140
; purge nozzle
G1 E25 F250
; zero extruders
G92 E0 E1
; move heatbed down a little more
G1 Z5.0 F20
; wait 600ms
G4 600
; move to tack down the strands
G1 X20.0 Y30.0 Z0 F9000
; wait 600ms
G4 600
;move up a bit
G1 Z5.0 F9000
; wait 300ms
G4 300
;fast move to center
G1 X152.5 Y152.5 F9000
T0
;Raise3D Job Start
M117 Printing...
M1001