STREAMCenter

So we've been using our S5 for about 6months and we love it. It's great and we always get really nice prints out of it. Recently though we have been seeing a slight bit of warping towards the bottoms of our prints. The last print we've had it basically warped the whole side of the print except for a small section of it. The red highlighted section is the only smooth portion and the blue highlighted section is the worst of it. I think I have all the pertinent settings listed below. We also have the material station and air manager installed. We've also only been using the Ultimaker PLA spools so far and this is the first real issue we've had. Any help would be greatly appreciated! Layer Height: Fine - 0.1 Infill Density: 20% Infill Pattern: Triangles Shell Thickness: 0.8/1.0 Print Speed: 70 mm/s Support Overhang Angle: 60 degrees