DMAC_AU

After a lot of digging around it has all come down to cooling just was not able to cool the part down fast enough at that speed. Thanks

Although this was a failed print, i can now assume that i have a printer issue rather then a software could even be Firmware related. I will do some digging around and keep the people updated. Thanks

Hey Greg, Thank you for your input and your advise, i will set up another slicer and give it a go and see if the results differ and will post back in here the result.

Hey Guys, I am reaching out to the wider community as i have tried everything i know but i am still getting issues with parts of my prints which is odd and not all parts of the print. As i can not explain this issue in printing terms (still a noob) i will add some photos regarding this and any input would be greatly appreciated. As for the more specifics Sliced with Cura 5.4 Its and ender 3 Pro Nozzel: 0.4 speed:130mm/s esun filiment running kipper Running mainsail input shaping has been configured manually (without accelerometer) Hotend @ 215 bed @ 60 Thanks in advance.