ModuloFS

Thank you for your help unfortunately the orientation does not change the behavior i always get the z-seam at my pocket... A workaround for this problem is to use two separate models, one inner model and one outer "shell" which is only one line thickness thick. But this is VERY inconvenient! And even if i do it that way, the speed of the print is changing at the pocket location. If i just print the outer shell alone, i do not get any change in the printing speed and i get a consistent wall. Halter_Lichterkette-Körper.stl Halter_Lichterkette-Körper001.stl AI3MSPRO_Halter_Lichterkette-Körper.3mf

Hello, i have a problem of getting cura to print my outer wall of the model in one continuous pass and only get on Z-seam. As you can see in the Picture i have a rectangular hole in the model an on one side of the model my wall is only one pass thick. My problem is that cura does the one line wall always separate and does not a continuous pass at the outside, this leads to a thick Z seam and it is a problem for me. I have already played around with different wall thicknesses around my nozzle diameter. Is there any way to tell Cura to do the outer wall in one single continuous pass with only one z-seam?? Thank you! Halter_Lichterkette-Körper.stl