greenieboy

ok wow slashee thanks i think you can stop printing balls now i tried putting a few of your ideas together like the slow speed and outer wipe and setting the z seam and i think i got it almost as good as yours its rough where the support came off and theres a few small blobs near the top but its a lot better than before i think i'll try getting some different tpu and see if works any better

wow slashee thanks for all that the tpu i've been using says it's "fast tpu" that goes at 75mm/s but i'll try printing it real slow and see if it makes a difference

i'm looking at the layer view and yours is filled in at the bottom, wont that make the middle of it hard and the rest is soft when i glue it?

i'm trying to make a bouncy ball out of tpu but on the lower half above wehre the support comes off theres a rough patch that goes all the way around, it happens every time and i don't know why can anyone help me with this. i've already tried using a different stl but the same thing happens