AXH_127

Yup that's gotta be it, I set the temp to 175, that's the lowest I've had to print at for this filament, didn't realize that the firmware wouldn't allow it, changed the 'extrude_mintemp = 160'. Thanks

Right just curious if anyone knew of a setting(s) that generally cause that to happen. I usually tweak things where I can to make the print better so not sure what I may have done to cause that to happen, I've heard of linear advance settings doing that but I didn't have that enabled, on top of the fact I don't recall changing anything when it started doing that but I must have somewhere. I have a lot of common settings adjusted for the filament I am using that's the only reason I'm trying to find the culprit.

Encountered a problem where the extruder gear stops after the first layer. Print continues as normal but the extruder gear simply does not engage once the first layer is done. I downloaded and sliced my model with the creality slicer (Creality Print) yesterday and that worked, extruder gear functioned properly and print came out normal. I'm assuming I have something checked in the Cura settings that my printer can't interpret as far as controlling the extruder motor goes? Not really sure, tried google-ing a couple things but couldn't find my exact problem, randomly happened, I don't remember changing any settings. (Creality Ender 3 S1 Pro)