finitfrog

I am USB printing because i have bought a new memory card due to the last one getting corrupted but when i put it in the slot it just slides in and doesn't read so i would give it a weak little pull to make sure its in and it just slides out and it doesn't detect it as connected. (i have tried making sure the card is valid and it is the right size i have a reader on my computer) Edit: I checked when I plug it in it does in fact click

Yes i checked it the model is not hovering Edit: ( I watched it print closely and it will make the line and then proceed to go up about a mm and try to print from there causing it to be too far from the build plate and hardening before it can hit the plate and causing a failure)

Hello I have a Creality CR-10 V2 and when i level using the main control panel it levels wayyy different than it does when i level with cure but then i would use the cura auto home and I would level it a click print when it heats up and starts printing the little line that it make come out fine but then it tries to print about half a mm off the build plate and i don't know how to fix it please help 😞